Range Rover Classic Inner Sill
They are made from Zintec coated mild steel
They are machine cut and CNC pressed for accuracy
You can buy any part of the inner sills separately if required, email me for a quote
They are made for either near side or off side but you can buy both sides if required.
Range Rover Classic Rear Crossmember
They are made from Zintec coated mild steel
They are machine cut and CNC pressed fro accuracy
As you can see from the photo they come complete with the mounting point brackets and door hinge brackets
If you require the mounts or any other part seperately thats not a problem, email me and i'll be able to give you a quote
Postage & packaging for one £9.50
Range Rover Classic, Discovery 200/300, Landrover 90/110 Rear Axle Shocker Bracket
The bracket is made from 5mm mild steel and laser cut for accuracy
£10.00 + £7.50 p&p
Discovery 200/300 TDI rear crossmember
They are made from 1.2 thick mild steel and are machine cut and CNC pressed for accuracy.
As you can see from the photo, they come complete with end panels and floor support. The door retainer is also supplied with washer and circlip.
Discovery 200/300 TDI Inner Sills
These inner sills will fit all Discovery 200/300 TDI
Made from Zintec coated mild steel
They have also been machine cut and CNC pressed for accuracy.
Rear Axle Coil Spring Mounting Bracket
Range Rover Classic/Discovery 200/300 & 90/110 Land Rivers front axle coil spring mounting bracket. Available in both near-side and off-side.
Made from 5mm mild steel, laser cut and CNC bent.
Front Axle Coil Spring Mounting Bracket
Range Rover Classis/Discovery 200/300 & 90/110 Land Rovers rear axle coil spring mounting brackets
Made from 5mm mild steel, laser cut and CNC bent.
Discovery/Range Rover
Made from 1.2mm thick mild steel.
The battery carrier is laser cut and also CNC pressed.
Discovery/Range Rover Classic Sills
The sills are 1500mm long, they will fit either a 3/5 door left or right hand.
One product does the lot up 1998 models.
Made from 1.2mm thick mild steel, which can easily be trimmed to suit. With the sills being extra lone this will enable you to get back to some sound metal to weld to.
Discovery/Range Rover Classic Inner Wing Repair Panel
These come in 3 parts for easy installation:
Part 'A' is the upstand
Part 'B' is the wheel arch
Part 'C' is a 25mm x 25mm x 600 long angle to be used as and where required, as every repair is different
These are made to an exceptionally high standard using 1.2mm mild steel.
Discovery Rear Cross Member Mounting Point Bracket
Instead of replacing the whole rear cross member on your Discovery - why not save time and money by just replacing the mounting point brackets?
The body is made from 1.6mm mild steel with a 5mm laser cut locating plate welded to the body.
The wings are extra wide to allow ease of welding.
The body is made from 1.6mm mild steel with a 5mm laser cut locating plate welded to the body.
The wings are extra wide to allow ease of welding.
Heavy Duty Defender/Series Tie Rod Axle Bracket
These are made from mild steel, 6mm thick
They are laser cut and CNC folded for accuracy.